Curioustab

Home » Mechanical Engineering » Strength of Materials

For riveting, the size of hole drilled in plates is __________ shank diameter of rivet.

equal to
less than
greater than

Correct Answer: greater than

← Previous Question Next Question→

More Questions from Strength of Materials

If the modulus of elasticity for a given material is twice its modulus of rigidity, then bulk modulus is equal to
When a body is subjected to two equal and opposite pulls, as a result of which the body tends to extend its length, the stress and strain induced is
The stress developed in the material without any permanent set is called
Two shafts 'A' and 'B' are made of same material. The shaft 'A' is of diameter D and shaft 'B' is of diameter D/2. The strength of shaft 'B' is __________ as that of shaft 'A'
The Young's modulus of a material is 125 GPa and Poissons ratio is 0.25. The modulus of rigidity of me material is
The unit of Young's modulus is same as that of stress.
Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as
The bending moment of a cantilever beam of length l and carrying a uniformly distributed load of w per unit length is __________ at the fixed end.
A continuous beam is one which is
In a beam of uniform strength, the bending stress developed is constant and is equal to the allowable stress at every section of the beam.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion