Curioustab

Home » Mechanical Engineering » Strength of Materials

The pull required to shear off a rivet, in double shear, per pitch length is

π/4 x d2 x σt
π/4 x d2 x τ
π/2 x d2 x σt
π/2 x d2 x τ

Correct Answer: π/2 x d2 x τ

← Previous Question Next Question→

More Questions from Strength of Materials

The ductility of the material __________ with the decrease in percentage elongation of a specimen under tensile test.
The section modulus (Z) of a beam is given by
The springs in cars are used to store strain energy.
The shear force of a cantilever beam of length l and carrying a gradually varying load from zero at the free end and w per unit length at the fixed end is __________ at the fixed end.
For riveting, the size of hole drilled in plates is __________ shank diameter of rivet.
If the modulus of elasticity for a given material is twice its modulus of rigidity, then bulk modulus is equal to
When a body is subjected to two equal and opposite pulls, as a result of which the body tends to extend its length, the stress and strain induced is
The stress developed in the material without any permanent set is called
Two shafts 'A' and 'B' are made of same material. The shaft 'A' is of diameter D and shaft 'B' is of diameter D/2. The strength of shaft 'B' is __________ as that of shaft 'A'
The Young's modulus of a material is 125 GPa and Poissons ratio is 0.25. The modulus of rigidity of me material is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion