Curioustab

Home » Mechanical Engineering » Steam Boilers and Engines

The average value of diagram factor lies between

0.2 to 0.5
0.5 to 0.65
0.65 to 0.9
0.8 to 1.2

Correct Answer: 0.65 to 0.9

← Previous Question Next Question→

More Questions from Steam Boilers and Engines

Which of the following is a fire tube boiler?
Fire tube boilers are limited to a maximum working pressure of
The diameter of superheated tubes in a locomotive boiler is
When the speed of the engine is controlled by means of a valve in a steam pipe, which regulates the pressure of steam entering the engine, then the governing is known as
For the same length of stroke and speed of crankshaft, the piston speed for a double acting steam engine is __________ the piston speed of single acting steam engine.
The ratio of the actual vacuum to the ideal vacuum in a condenser is called
The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height ot the chimney in metres, and T1 = Absolute temperature of air outside the chimney in K)
A receiver type compound engine, requires a lighter flywheel.
The device attached to the steam chest for preventing explosions due to excessive internal pressure of steam is called
The high steam and low water safety valve is not used in

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion