Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
The tool may fail due to
cracking at the cutting edge due to thermal stresses
chipping of the cutting edge
plastic deformation of the cutting edge
all of these
Correct Answer:
all of these
← Previous Question
Next Question→
More Questions from
Production Engineering
If the shear angle is large and the chip-tool contact area is low, then the tool life will be more.
As the cutting speed increases, the tool cutting forces
In machining metal, cutting force at the cutting edge is measured by a
A feed gear box for a screw cutting lathe is designed on the basis of
The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is
In ultra-sonic machining, tool is made of
In oblique cutting system, the tool may or may not generate a surface parallel to the workface.
Mild steel during machining produces __________ chips.
The chamfering is an operation of
The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments