Curioustab

Home » Mechanical Engineering » Production Engineering

In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is

depth of cut
cutting speed
feed
tool rake angle

Correct Answer: cutting speed

← Previous Question Next Question→

More Questions from Production Engineering

A better machinable metal is one which gives
Which of the following statement is correct about hot machining?
Ceramic cutting tools are
Spot facing is an operation of smoothing and squaring the surface around a hole.
The tail stock and the carriage of a lathe may be guided on same or different guideway.
In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.
In centreless grinders, the regulating wheel is inclined at
The average cutting speed for turning mild steel with a high speed steel tool is
A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is
The taper on the lathe spindle is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion