Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
If the shear angle is large and the chip-tool contact area is low, then the tool life will be more.
Correct
Incorrect
Correct Answer:
Correct
← Previous Question
Next Question→
More Questions from
Production Engineering
As the cutting speed increases, the tool cutting forces
In machining metal, cutting force at the cutting edge is measured by a
A feed gear box for a screw cutting lathe is designed on the basis of
The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is
In ultra-sonic machining, tool is made of
In oblique cutting system, the tool may or may not generate a surface parallel to the workface.
Mild steel during machining produces __________ chips.
The chamfering is an operation of
The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called
Soft materials can not be economically ground due to
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments