Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
In American Standard Association (A S A) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be
5°
6°
8°
10°
Correct Answer:
6°
← Previous Question
Next Question→
More Questions from
Production Engineering
The hard grade grinding wheels are denoted by the letters
In twist fluted drills, chips do not move out automatically.
The grinding of long, slender shafts or bars is usually done by
The tool may fail due to
If the shear angle is large and the chip-tool contact area is low, then the tool life will be more.
As the cutting speed increases, the tool cutting forces
In machining metal, cutting force at the cutting edge is measured by a
A feed gear box for a screw cutting lathe is designed on the basis of
The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is
In ultra-sonic machining, tool is made of
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments