Curioustab

Home » Electronics » Operational Amplifiers

A circuit that uses an amplifier with passive filter elements is called a(n):

relaxation oscillator
signal generator
differential amplifier
active filter

Correct Answer: active filter

← Previous Question Next Question→

More Questions from Operational Amplifiers

What is the output waveform?
Input impedance [Zin(I)] of an inverting amplifier is approximately equal to:
What is the output voltage?
If ground is applied to the (+) terminal of an inverting op-amp, the (–) terminal will:
If a noninverting amplifier has an RIN of 1000 ohms and an RFB of 2.5 kilohms, what is the RIN voltage when 1.42 mV is applied to the correct input?
What is the difference between common-mode and differential-mode input signals?
If the feedback/input resistor ratio of a feedback amplifier is 4.6 with 1.7 V applied to the noninverting input, what is the output voltage value?
In an open-loop op-amp circuit, whenever the inverting input (–) is negative relative to the noninverting input (+), the output will:
The ratio between differential gain and common-mode gain is called:
A circuit whose output is proportional to the difference between the input signals is considered to be which type of amplifier?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion