Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
Bipolar Junction Transistors (BJT)
Three different Q points are shown on a dc load line. The upper Q point represents the:
minimum current gain
intermediate current gain
maximum current gain
cutoff point
Correct Answer:
maximum current gain
← Previous Question
Next Question→
More Questions from
Bipolar Junction Transistors (BJT)
A current ratio of IC/IE is usually less than one and is called:
Most of the electrons in the base of an NPN transistor flow:
The symbol hfe is the same as:
The C-B configuration is used to provide which type of gain?
A transistor may be used as a switching device or as a:
If a transistor operates at the middle of the dc load line, a decrease in the current gain will move the Q point:
If VCC = +18 V, voltage-divider resistor R1 is 4.7 kΩ, and R2 is 1500Ω, what is the base bias voltage?
What is the collector current for a C-E configuration with a beta of 100 and a base current of 30 µA?
With low-power transistor packages, the base terminal is usually the:
The Q point on a load line may be used to determine:
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments