Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
Alternating Current vs Direct Current
Test equipment selection enables the technician to both generate signals and:
change circuit conditions
inject signals
sense circuit conditions
change signal frequencies
Correct Answer:
sense circuit conditions
← Previous Question
Next Question→
More Questions from
Alternating Current vs Direct Current
What is the rms voltage value of an ac signal whose peak oscilloscope display uses 3 major divisions above the zero setting? (V/cm = 5)
Signal comparisons may be most easily seen when using which item of test equipment?
If current varies periodically from zero to a maximum, back to zero, and then repeats, the signal is:
Power companies supply ac, not dc, because:
If a sine wave signal is 100 mV peak-to-peak, how many volts would be measured by a voltmeter?
One oscilloscope selector knob that allows the major and minor divisions of the graticule to be used to determine a signal amplitude value is called the:
What is the name of a device used to directly measure the frequency of a periodic wave?
A test equipment item that has the ability to produce either square, triangular, or sawtooth waveforms is called:
The distance that a signal's energy can travel in the time it takes for one cycle to occur is called the signal's:
Why is ac current transfer more effective than dc current transfer over long distances?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments