Curioustab

Home » Electronics and Communication Engineering » Networks Analysis and Synthesis

The circuit in figure will act as ideal current source with respect to terminals A and B when frequency is

0
1 rad/sec
4 rad/sec
16 rad/sec

Correct Answer: 1 rad/sec

Explanation:

When ω = 4 rad/sec ωL and are equal.

← Previous Question Next Question→

More Questions from Networks Analysis and Synthesis

In the circuit shown in given figure, the values of i(0+) and I(∞), will be respectively
and i(t) is a unit step, then V(t) in the steady state is given by
Which of the following pairs are correctly matched? Brune's realisation : realisation with ideal transformer. Cauer realisation : ladder realisation. Bott Duffin realisation : with non ideal transformer. Select the answer using the following codes:
In a minimum function
An RLC series circuit is underdamped. To make it overdamped, the value of R
A sinusoidal voltage has peak to peak value of 100 V. The rms value is
A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is
A 3 phase balanced supply feeds 3 phase unbalanced load. Power supplied to the load can be measured by using 2 wattmeter one wattmeter 3 wattmeter Which of the above statements is correct?
The driving-point impedance Z(s) of a network has a pole-zero locations as shown in the figure. If Z(0) = 3, then Z (s) is
The degree of the nodes 1, 2, 3, 4 is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion