Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Networks Analysis and Synthesis
A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V
Correct Answer:
2 x 230V
Explanation:
Peak voltage rating =
2
(rms voltage rating).
← Previous Question
Next Question→
More Questions from
Networks Analysis and Synthesis
For node 1 in figure, KCL equation is
Which of the following is correct for a driving point functions?
For a transmission line open circuit and short circuit impedances are 20 Ω and 5 Ω. Then characteristic impedance is
In figure, the current supplied by battery immediately after switching on the circuit is
A cable has an insulation resistance of 1010 ohms. If the length is doubled, the insulation resistance will be
A series RL circuit has . If a voltage 4 sint + 4t is applied, the steady state current will be
The drift velocity of electrons is
In a parallel resonant circuit, the circuit current at resonance is maximum.
The terms RMS and average values apply only to sine waves.
In an ac circuit, the maximum and minimum values of power factor can be
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments