In terms of R, L, G and C the propagation constant γ of a transmission line is

More Questions from Microwave Communication

• Consider the following statements (L is the length of array between centres of end antennas and A is wave-length) Width of major lobe between nulls of broad side array and end fire array are different. Directive gain of broadside array and end fire array are different. Directive gain of broadside array is 4 Which of the above statements are correct?
• If a microstrip is enclosed in a metal enclosure
• In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about
• Loading of a line means
• A rectangular waveguide has two stubs each length connected at the source end. The stubs are short circuted. Then
• A transmission line discontinuity is defined as any interruption in the uniformity of the line.
• Interference generated by electrical equipment and automobile ignition systems when observed closed to earth is
• Which of the following is a balanced line?
• Consider the following statements Usable bandwidth of ridge wave guide is more than that of rectangular waveguide. For a given value of TM10 cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide. Ridge wave guide has higher conductor losser than a rectangular waveguide. Ridge guide has higher conductor losser than a rectangular waveguide. Which of the above statements are correct?
• To study electromagnetic radiations from astronomical objects, radio astronomers use

Discussion & Comments