Curioustab

Home » Electronics and Communication Engineering » Microwave Communication

In the given figure the time taken by the wave to make one round trip is

10 ns
20 ns
30 ns
40 ns

Correct Answer: 40 ns

Explanation:

← Previous Question Next Question→

More Questions from Microwave Communication

In microwave networks, a uniform waveguide section behaves like which type of filter around its cutoff?
A transmission line has a load reflection coefficient Γ = 0.2 ∠45°. What is the standing-wave ratio (SWR) on the line?
Skin effect becomes more pronounced as the operating frequency increases. Is this statement accurate for practical conductors?
In a backward-wave oscillator (BWO), does the guided RF wave physically 'wind back and forth' along the line?
At its design frequency, a quarter-wave open-circuited stub is equivalent to which reactive network at its input?
Assertion–Reason: Artificial transmission lines are frequently used in laboratories. Reason: Such lines can emulate real lines and function as delay elements, attenuators, and filter networks. Which statement is correct?
In a traveling-wave tube (TWT) amplifier, how does the amplitude of the resultant RF wave along the helix vary under small-signal operation?
In a turnstile antenna, two half-wave resonant wire radiators are placed 90° apart in the same plane. How should they be excited to obtain the desired omnidirectional pattern and circular polarization?
In a backward-wave oscillator (BWO), which adjustment most effectively tunes the oscillation frequency?
Assertion–Reason (Transmission Lines): A matched load has impedance equal to the line’s characteristic impedance because a matched termination absorbs all incident power without reflection.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion