Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Measurements and Instrumentation
Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?
Measurement of unknown voltage
Measurement of resistance
Measurement of unknown current
Calibration of voltmeter
Correct Answer:
Measurement of resistance
Explanation:
Unknown resistance is compared with a standard resistance. Therefore standardisation of potentiometer is not necessary.
Next Question→
More Questions from
Measurements and Instrumentation
The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10-6 N-m on full scale. If B = 1 Wb/m2, range of meter is
Which of the following are needed both for protection and metering?
Figure shows an RC potentiometer to measure ac voltage. It is desired that V0/Vi should be independent of frequency. The value of C should be
Two resistors R1 = 36 Ω ± 5% and R2 = 75 Ω ± 5% are connected in series. The total resistance is
The speed transducer using a drag cup rotor has the main advantage of
A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
It is required to measure angular position. Out of the transducers Circular potentiometer LVDT E pick up Synchro The proper devices are
A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
Assertion (A): De sauty's bridge is suitable only for pure capacitor. Reason (R): Capacitors are mostly perfect.
In figure, Z1 = 200∠60° Ω, Z2 = 400∠ - 90° Ω, Z3 = 300∠0°. Then Z4 for bridge to be balanced is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments