Home » Electronics and Communication Engineering » Electromagnetic Field Theory

Which one of the following does represents the electric field lines for the TE02 mode in the cross section of a hollow rectangular metallic waveguide?

Q: Which one of the following does represents the electric field lines for the TE02 mode in the cross section of a hollow rectangular metallic waveguide?

TE02 ⟹ m = 0, n = 2 in x direction no propagation, only in y, and normal to the waveguide, tangential component is continuous.

Correct Answer:

Explanation:

TE₀₂ ⟹ m = 0, n = 2

in x direction no propagation, only in y, and normal to the waveguide, tangential component is continuous.

← Previous Question Next Question→

More Questions from Electromagnetic Field Theory

A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its Brewster angle is
For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the value of propagation constant P will be
The Depth of penetration of EM wave in medium having conductivity σ at a frequency of 1 MHz is 25 cm. The depth of penetration at a frequency of 4 MHz will be
Radiation intensity of a dipole depends strongly on frequency. If at a frequency f, the intensity of radiation is 'I'. Then at a frequency of f/2, the intensity will be
The divergence of the electric field intensity at any point equals
A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
A rectangular metal waveguide filled with a dielectric of relative permittivity εr = 4, has the inside dimensions 3 x 1.2 cm, the cut off frequency for the dominant mode is
Two identical antennas are placed in the θ = p/2 plane as shown in the figure. The elements have equal amplitude excitation with 180° polarity difference, operating of the far-zone resultant electric field strength normalized with that of a single element, both computed for φ = 0, is
Calculate the directivity of an antenna for θE = 30°, θH = 60
A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion