Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Electromagnetic Field Theory
Radiation intensity of a dipole depends strongly on frequency. If at a frequency f, the intensity of radiation is 'I'. Then at a frequency of f/2, the intensity will be
Correct Answer:
Explanation:
I ∝
f
.
← Previous Question
Next Question→
More Questions from
Electromagnetic Field Theory
The divergence of the electric field intensity at any point equals
A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
A rectangular metal waveguide filled with a dielectric of relative permittivity εr = 4, has the inside dimensions 3 x 1.2 cm, the cut off frequency for the dominant mode is
Two identical antennas are placed in the θ = p/2 plane as shown in the figure. The elements have equal amplitude excitation with 180° polarity difference, operating of the far-zone resultant electric field strength normalized with that of a single element, both computed for φ = 0, is
Calculate the directivity of an antenna for θE = 30°, θH = 60
A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth
A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.
A (75 - j 40) W load is connected to a co-axial line of z0 = 75ω at 6 MHz. The load matching on the line can be accomplished by connecting
The electric field of the incident wave is , where ω = 3 x 109p and β = 10 p. The electric field of the transmitted wave Et is given by
The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε0. The surface charge density on the conductor is ((ε0 = 10-9/36p)F/m)
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments