Home » Electrical Engineering » Series-Parallel Circuits

A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?

0.57 V
6 V
12 V
5.7 V

Correct Answer: 5.7 V

← Previous Question Next Question→

More Questions from Series-Parallel Circuits

The parallel combination of a 470 Ω resistor and a 1.2 kΩ resistor is in series with the parallel combination of three 3 kΩ resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of
A balanced Wheatstone bridge consists of an RV of 3,500 Ω, an R2 of 200 Ω, and an R3 of 680 Ω. The value of RUNK is
Two 1.2 kΩ resistors are in series and this series combination is in parallel with a 3.3 kΩ resistor. The total resistance is
The output of a certain voltage divider is 12 V with no load. When a load is connected, the output voltage
A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is
The internal resistance of a 30,000 ohm/volt voltmeter set on its 50 V range is
The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 kΩ resistor is
A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately
A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion