Curioustab

Home » Electrical Engineering » Series-Parallel Circuits

A balanced Wheatstone bridge consists of an RV of 3,500 Ω, an R2 of 200 Ω, and an R3 of 680 Ω. The value of RUNK is

680 Ω
1,029 Ω
200 Ω
880 Ω

Correct Answer: 1,029 Ω

← Previous Question Next Question→

More Questions from Series-Parallel Circuits

Two 1.2 kΩ resistors are in series and this series combination is in parallel with a 3.3 kΩ resistor. The total resistance is
The output of a certain voltage divider is 12 V with no load. When a load is connected, the output voltage
A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is
The internal resistance of a 30,000 ohm/volt voltmeter set on its 50 V range is
The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 kΩ resistor is
A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately
A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?
A certain Wheatstone bridge has the following resistor values: R1 = 10 kΩ, R2 = 720 Ω, and R4 = 2.4 kΩ. The unknown resistance is
The internal resistance of a 20,000 ohm/volt voltmeter set on its 5 V range is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion