Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electrical Engineering
»
Series-Parallel Circuits
The internal resistance of a 30,000 ohm/volt voltmeter set on its 50 V range is
15,000 Ω
150,000 Ω
1,500,000 Ω
15,000,000 Ω
Correct Answer:
1,500,000 Ω
← Previous Question
Next Question→
More Questions from
Series-Parallel Circuits
The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 kΩ resistor is
A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately
A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?
A certain Wheatstone bridge has the following resistor values: R1 = 10 kΩ, R2 = 720 Ω, and R4 = 2.4 kΩ. The unknown resistance is
The internal resistance of a 20,000 ohm/volt voltmeter set on its 5 V range is
The parallel combination of a 470 Ω resistor and a 680 Ω resistor is in series with the parallel combination of four 2 kΩ resistors. The total resistance is
A certain circuit is composed of two parallel resistors. The total resistance is 1,403 Ω. One of the resistors is 2 kΩ. The other resistor value is
When a load resistance is removed from the output of a voltage divider circuit, the current drawn from the source
Two 3.3 kΩ resistors are in series and this series combination is in parallel with a 4.7 kΩ resistor. The voltage across one of the 3.3 kΩ resistors is 12 V. The voltage across the 4.7 kΩ resistor is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments