Curioustab

Home » Digital Electronics » Digital System Projects Using HDL

In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.

SIGNAL
FUNCTION
CASE
PROCESS

Correct Answer: PROCESS

← Previous Question Next Question→

More Questions from Digital System Projects Using HDL

The timing and control block provides the ________ for the frequency counter.
Using one case construct inside another is known as ________.
In the digital clock project, the 60 Hz signal is sent through a Schmitt-trigger circuit to produce square pulses at the rate of ________.
In the keypad encoder, the ________ activate(s) the freeze bit only when one column is low.
A very critical dimension in project management is ________.
The interface of the stepper motor needs to operate in one of ________ mode(s).
In the keypad encoder, just after the 4 ms mark, the simulation initiates the release of the key by changing the column value to ________, which causes the d output to go into its Hi-Z state.
In the digital clock design, the hours section is different from the seconds and minutes section in that it never goes to ________.
One aspect of project planning and management is the selection of ________ that will best fit the application.
In the digital clock project, the 1 pps signal is used as a synchronous clock for all of the counter stages, which are ________.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion