Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Digital System Projects Using HDL
In the keypad encoder, just after the 4 ms mark, the simulation initiates the release of the key by changing the column value to ________, which causes the d output to go into its Hi-Z state.
0 hex
4 hex
8 hex
F hex
Correct Answer:
F hex
← Previous Question
Next Question→
More Questions from
Digital System Projects Using HDL
In the digital clock design, the hours section is different from the seconds and minutes section in that it never goes to ________.
One aspect of project planning and management is the selection of ________ that will best fit the application.
In the digital clock project, the 1 pps signal is used as a synchronous clock for all of the counter stages, which are ________.
Each ________, starting at the simplest level, should be built in HDL.
In the frequency counter, the control clock is derived from the ________ by frequency dividers controlled in the control and timing block.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments