Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
The maximum liquid gradient over a tray must not exceed
Options- A. 0.5" -1.25".
- B. 2"-3.5".
- C. 5".
- D. half the tray spacing.
- Correct Answer
- 0.5" -1.25".
- 1. Thin spherical shells subjected to internal pressure, develop __________ stresses.
Options- A. radial
- B. circumferential
- C. both (a) & (b)
- D. neither (a) nor (b) Discuss
- 2. In packed towers provided with saddle packing, liquid redistributors are positioned at every __________ times column diameter or 6 metres whichever is less.
Options- A. 2-3
- B. 5-8
- C. 10-15
- D. 20-25 Discuss
- 3. In a shell and tube heat exchanger, tube side __________ of the mass velocity.
Options- A. heat transfer co-efficient is proportional to 0.8th power
- B. pressure drop is proportional to the square
- C. both 'a' & 'b'
- D. neither 'a' nor 'b' Discuss
- 4. Floating head heat exchangers are used for the
Options- A. heat transfer between corrosive fluids.
- B. cases where temperature difference between the shell and the tubes is more (>50°C).
- C. co-current heat transfer systems.
- D. counter-current heat transfer systems. Discuss
- 5. In case of a continuous distillation column, increase in reflux ratio may result in the
Options- A. lower fixed charges for the column.
- B. greater cost for the reboiler heat supply.
- C. greater cost for the condenser coolant.
- D. all (a), (b) and (c). Discuss
- 6. Overall tray efficiency of a distillation column is the ratio of the number of
Options- A. overall gas transfer units to the number of ideal trays required.
- B. ideal trays required to the number of real trays required.
- C. real trays required to the number of ideal trays required.
- D. none of these. Discuss
- 7. Which of the following types of reactors is the safest from operation point of view?
Options- A. A vapor phase reactor.
- B. Pot type reactor.
- C. A liquid phase reactor.
- D. A liquid phase catalytic reactor. Discuss
- 8. Pick out the wrong statement pertaining to 'Horton sphere' used for the storage of liquid ammonia.
Options- A. Diameter of Horton sphere is normally 6 to 25 metres and it is supported by 6 to 12 nos. tubular or rolled section column.
- B. Thickness of spherical shell is half that of the cylinderical vessel under same operating pressure condition. Besides, the ratio of surface area to volume is less for sphere than any other shape ; hence insulation required is less.
- C. Horton sphere is used for the storage of gases and volatile liquid at a moderate pressure of 1 to 10 kg/cm2 .
- D. Horton sphere is used for the storage of liquid at sub-zero temperature at very high pressure upto 200 kg/cm2 . Discuss
- 9. Normal screwed fittings are used for pipes upto a diameter of __________ inches.
Options- A. 1.5
- B. 3
- C. 5
- D. 7 Discuss
- 10. A perforated plate has holes of diameter dn arranged in a pitch ph. Each hole has a tube of I.D. dt passing through it. The ligament efficiency is given by
Options- A. (ph - dh)/ph
- B. (ph - dh . dt/2)/ph
- C. (ph - dt)/ph
- D. (ph - dh)/dh Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: radial
Correct Answer: 5-8
Correct Answer: both 'a' & 'b'
Correct Answer: cases where temperature difference between the shell and the tubes is more (>50°C).
Correct Answer: all (a), (b) and (c).
Correct Answer: ideal trays required to the number of real trays required.
Correct Answer: A vapor phase reactor.
Correct Answer: Horton sphere is used for the storage of liquid at sub-zero temperature at very high pressure upto 200 kg/cm2 .
Correct Answer: 3
Correct Answer: (ph - dt)/ph
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.