logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Agitation and Aeration Comments

  • Question
  • A fermentation system has a KLa of 3 s-1 and a C0* of 5 ppm of O2. If the bulk liquid is saturated with oxygen then the oxygen transfer rate will be equal to


  • Options
  • A. zero
  • B. 3 mg.l-1.s-1
  • C. 5 mg.l-1.s-1
  • D. 15 mg.l-1.s-1

  • Correct Answer
  • zero 


  • Agitation and Aeration problems


    Search Results


    • 1. In aerobic microorganisms cultures radial flow impellers are used because

    • Options
    • A. they provide energy efficient high turbulent mixing conditions
    • B. they provide low shear mixing conditions
    • C. they provide high shear mixing conditions
    • D. they ensure that bubble size is maximized leading to high oxygen transfer rates
    • Discuss
    • 2. Impeller damage can be minimized by

    • Options
    • A. using specially designed axial flow impellers
    • B. using radial flow impellers
    • C. using Intermig impellers
    • D. all of the above
    • Discuss
    • 3. A fermentation system has a KLa of 3 s-1 and a C0* of 5 ppm of O2. If the bulk liquid is completely depleted of oxygen, then the oxygen transfer rate will be equal to

    • Options
    • A. zero
    • B. 15 mg.l-1.s-1
    • C. 10 mg.l-1.s-1
    • D. 5 mg.l-1.s-1
    • Discuss
    • 4. During fermentation, the saturation concentration of oxygen was reduced from 7 ppm. to 1 ppm. Which one of the following conclusions can be drawn?

    • Options
    • A. Microbial growth is oxygen limited since the oxygen concentration is lesser than the saturation concentration
    • B. Microbial growth is not oxygen limited since the oxygen concentration is lesser than the saturation concentration
    • C. Experimental error leads to the reduction
    • D. No conclusion can be drawn
    • Discuss
    • 5. For aerated mixing vessels in an aqueous solution, the mass transfer coefficient (kL) co-relating power consumption (Pm) and fermenter volume (V) can be expressed as

    • Options
    • A. kL ? (Pm/V)0.33
    • B. kL ? (Pm/V)0.66
    • C. kL ? (Pm/V)0.50
    • D. kL ? (Pm/V)
    • Discuss
    • 6. If the stirrer speed is too slow, bubbles will accumulate and coalescese under the impeller. This phenomenon is known as a

    • Options
    • A. coalesced impeller
    • B. flooded impeller
    • C. river impeller
    • D. dry impeller
    • Discuss
    • 7. A reactor has a total volume of 50,000 litres. If it has a headspace volume of 10,000 litres, then volume of liquid in the reactor will be

    • Options
    • A. 10,000 l
    • B. 20,000 l
    • C. 30,000 l
    • D. 40,000 l
    • Discuss
    • 8. Reynolds (Rei) number for the impeller is given by (where Di, stirrer diameter; N, stirrer speed, ?, density of fluid and ?, viscosity of fluid)

    • Options
    • A. DiV?/?
    • B. Di2N?/?
    • C. Di2V?/?
    • D. DiN? /?
    • Discuss
    • 9. The advantage of axial flow impellers over radial flow impellers is that axial flow impellers

    • Options
    • A. provide better lift of solids
    • B. provide high shear conditions
    • C. provide low shear conditions
    • D. are cheaper to build
    • Discuss
    • 10. In a bioreactor, if at a particular time the oxygen transfer rate is 23 kg.h-1, then the oxygen uptake will be

    • Options
    • A. 23 kg.h-1
    • B. less than 23 kg.h-1
    • C. greater than 23 kg.h-1
    • D. 2.3 kg.h-1
    • Discuss


    Comments

    There are no comments.

Enter a new Comment