logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Computer Hardware Comments

  • Question
  • You should never put floppy drives, hard drives, or even VCR tapes or cassette tapes on top of speakers (or near any other source of magnetism) because of:


  • Options
  • A. RFI
  • B. EMI
  • C. EXE
  • D. FYI
  • E. IOU

  • Correct Answer
  • EMI 


  • Computer Hardware problems


    Search Results


    • 1. What would you ask to determine if the display is working?

    • Options
    • A. Is there a video cursor or action on the screen?
    • B. Did the computer beep or chime?
    • C. Is there high voltage static on the screen
    • D. Is the brightness or contrast turned up or down?
    • E. All of the above
    • Discuss
    • 2. You suspect a virus has entered your computer. What will not be affected by the virus?

    • Options
    • A. CMOS
    • B. Boot sector
    • C. Floppy disks
    • D. Program files
    • E. None of the above
    • Discuss
    • 3. To find out how much memory is available, you could type _____

    • Options
    • A. EMM
    • B. MEM
    • C. CHKDSK
    • D. MEMMAKER
    • E. None of the above
    • Discuss
    • 4. What is the size of a sector?

    • Options
    • A. 512 bytes
    • B. 256 bytes
    • C. 512 Kb
    • D. 1024 bytes
    • E. None of the above
    • Discuss
    • 5. What command is used to hang up a MODEM when using the "AT Command set"?

    • Options
    • A. ATZ
    • B. ATD
    • C. ATR
    • D. ATH
    • E. None of the above
    • Discuss
    • 6. Current is measured in units of:

    • Options
    • A. volts
    • B. amps
    • C. ohms
    • D. farads
    • E. diodes
    • Discuss
    • 7. In which mode can two or more applications be stored in memory at the same time?

    • Options
    • A. Segmented Mode
    • B. Unprotected Mode
    • C. Real Mode
    • D. Protected Mode
    • E. None of the above
    • Discuss
    • 8. RTS stands for:

    • Options
    • A. ready to start
    • B. ready to switch
    • C. request to send
    • D. request to scan
    • E. ready to set
    • Discuss
    • 9. When connecting a ribbon cable to a connector, how do you know which direction to plug it in?

    • Options
    • A. The red line in the cable goes to the highest pin number
    • B. The colored line in the cable goes to pin #1
    • C. It does not matter
    • D. The blue or red line in the cable goes away from the power connector
    • E. None of the above
    • Discuss
    • 10. In which phase of the laser printing process is a positive charge placed on the paper to pull the toner from the print drum?

    • Options
    • A. Writing
    • B. Transferring
    • C. Conditioning
    • D. All of the above
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment