Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Computer Science
»
Computer Hardware
To install a second IDE drive into a computer, you must:
Set the master-slave jumper to slave on the second drive
Use the IDE configuration software to set the new drive as slave
Verify that you define the new drive as D: in the CMOS setup
Verity that you attach the drive to the connector at the end of the ribbon cable
None of the above
Correct Answer:
Set the master-slave jumper to slave on the second drive
← Previous Question
Next Question→
More Questions from
Computer Hardware
How many pins on a VGA?
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
In which mode can 2 or more applications be stored in memory at the same time?
When configuring is a network interface cards without jumpers or plug and play, what is used to set the IRQs?
To prevent toner from sticking to a laser printer's heat rollers, apply which of the following:
During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.
What is modified when changing the system start-up boot sequence?
After doing a low-level format, what would be the next step in configuring the hard drive in a system?
What is the best ground for a conductive work bench?
Match the device driver HIMEM.SYS to its operation.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments