Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Computer Science
»
Computer Hardware
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
MEM /P
MEMMAKER
MEM /C (A SYS:
None of the above
Correct Answer:
MEM /C (A SYS:
← Previous Question
Next Question→
More Questions from
Computer Hardware
In which mode can 2 or more applications be stored in memory at the same time?
When configuring is a network interface cards without jumpers or plug and play, what is used to set the IRQs?
To prevent toner from sticking to a laser printer's heat rollers, apply which of the following:
During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.
What is modified when changing the system start-up boot sequence?
After doing a low-level format, what would be the next step in configuring the hard drive in a system?
What is the best ground for a conductive work bench?
Match the device driver HIMEM.SYS to its operation.
To find out how much memory is available, you could type _____
You suspect a virus has entered your computer. What will not be affected by the virus?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments