logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Microwave Communication Comments

  • Question
  • In Reflex Klystron oscillator the focussing electrode is at a high potential


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    Explanation
    It uses a single cavity resonator for generating microwave oscillations.

    Its parts are electron gun, resonator, repeller and output coupling.

    It operates on the principle of positive feed back.

    The repeller electrode is at negative potential and sends the partially bunched electron beam back to resonator cavity.

    This positive feedback supports oscillations. Its feature are:

    1. Frequency range - 2 to 100 GHz

    2. Power output - 10 MW to about 2 W

    3. Efficiency - 10 - 20 %

    Its applications include radar receivers, local oscillator in microwave devices, oscillator for microwave measurements in laboratories etc.


    Microwave Communication problems


    Search Results


    • 1. If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is

    • Options
    • A. 20 dB more
    • B. 20 dB less
    • C. 700 dB more
    • D. 100 dB less
    • Discuss
    • 2. In the given figure the reflected voltage wave after first reflection is

    • Options
    • A. 18 V
    • B. -18 V
    • C. 30 V
    • D. -30 V
    • Discuss
    • 3. A quarter wave line short circuited at load end behaves as

    • Options
    • A. an inductance
    • B. an inductance and capacitance in series
    • C. a capacitance
    • D. an inductance and capacitance in parallel
    • Discuss
    • 4. Assertion (A): A line of length and short circuited at far end has an input impedance of infinity.

      Reason (R): A line of length and short circuited at far end behaves as a parallel resonant circuit.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 5. A duplexer is used to

    • Options
    • A. couple two antennas to a transmitter
    • B. isolate the antenna from the local oscillator
    • C. prevent interference between two antennas connected to receiver
    • D. use an antenna for reception or transmission without interference
    • Discuss
    • 6. Assertion (A): PIN diode can be used as attenuator and limiter.

      Reason (R): PIN diode has a thin intrinsic layer.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 7. For the strip line in the given figure the capacitance per unit length =

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 8. A magnetron has a cylindrical cathode surrounded by an anode structure having cavities opening into interaction space by means of slots

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. A loss less line is terminated in a circular lines are E lines

    • Options
    • A. SWR = 0
    • B. SWE = 0
    • C. SWR is finite
    • D. SWR = ?
    • Discuss
    • 10. The directivity in a receiving antenna

      1. increases the intercept area in forward direction
      2. reduces the noise picked up from other sources
      3. provides a means of discriminating against undesired signals originating in directions other than in which the desired transmitter lies.
      Which of the above statements are correct?

    • Options
    • A. 1 only
    • B. 1 and 2 only
    • C. 1, 2 and 3
    • D. 2 and 3 only
    • Discuss


    Comments

    There are no comments.

Enter a new Comment