logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Structural Design Specifications Comments

  • Question
  • For under water concreting.


  • Options
  • A. at least 10 percent more cement is required as compared to dry conditions
  • B. the volume of coarse aggregates shall not be less than one and half times and not more than twice that of fine aggregate
  • C. the slump should not be less than 100 mm and not more than 180 mm
  • D. dewatering by pumping is not done or until 24 hours thereafter
  • E. All the above

  • Correct Answer
  • All the above 


  • Structural Design Specifications problems


    Search Results


    • 1. The greater clear dimension of web of thickness't' should not exceed

    • Options
    • A. 180 t
    • B. 200 t
    • C. 240 t
    • D. 270 t
    • Discuss
    • 2. The thickness of flat single lacing is, taken (where l is effective length of the bar).

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 3. The actual length of a column provided with a cap and base, is the distance between

    • Options
    • A. top of the base and underside of the cap
    • B. bottom of the base and underside of the cap
    • C. top of the base and top of the cap
    • D. bottom of the base and top of the cap.
    • Discuss
    • 4. The thickness of the rectangular plate for the cap or base of a solid round steel columns, is calculated from the formula where d is

    • Options
    • A. the reduced diameter of the column
    • B. the dimension of the base
    • C. the diameter of the base
    • D. the diameter of the top.
    • Discuss
    • 5. The anchorage value of standard U-type hook of a reinforcing bar of diameter d in tension, is

    • Options
    • A. 4 d
    • B. 8 d
    • C. 12 d
    • D. 16 d
    • E. 20 d
    • Discuss
    • 6. Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept

    • Options
    • A. zero
    • B. 1.2 m
    • C. 0.9 m
    • D. 0.75 m
    • Discuss
    • 7. In the formula

    • Options
    • A. A and B are the dimensions of the column
    • B. A and B are the dimensions of the base plate
    • C. A is the greater projection of the plate beyond the column
    • D. B is the lesser projection of the plate beyond the column
    • E. Both (c) and (d) of above.
    • Discuss
    • 8. The staggered pitch is the distance between two consecutive rivets measured

    • Options
    • A. parallel to the direction of stress in the member
    • B. perpendicular to the direction of stress in the member
    • C. diagonally
    • D. none of these.
    • Discuss
    • 9. A column of rectangular section is considered short, if both the slenderness ratios are less than

    • Options
    • A. 8
    • B. 10
    • C. 12
    • D. 16
    • Discuss
    • 10. If a and b are the sides of a square column and its base, the thickness of the base may be calculated from the formula

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment