Curioustab

Home » Civil Engineering » Steel Structure Design

Diameter of a rivet hole is made larger than the diameter of the rivet by

1.0 mm for rivet diameter upto 12 mm
1.5 mm for rivet diameter exceeding 25 mm
2.0 mm for rivet diameter over 25 mm
none of these.

Correct Answer: 2.0 mm for rivet diameter over 25 mm

← Previous Question Next Question→

More Questions from Steel Structure Design

Factor of safety is the ratio of
When the length of a tension member is too long
Bulb angles are used in
IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every
Effective sectional area of a compression member is :
A single angle in tension is connected by one leg only. If the areas of connecting and outstanding legs are respectively a and b, net effective area of the angle, is
With a percentage increase of carbon in steel, decreases its
The central deflection of a simply supported steel beam of length L with a concentrated load W at the centre, is
According to the Unwin's formula, if t is thickness of the plate in mm, the nominal diameter of the rivet, is
If M is the moment due to a couple in a bearing plate whose width is b and allowable bending stress is P, the thickness (t) of the bending plate of the column splice, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion