Curioustab

Home » Civil Engineering » Steel Structure Design

The main advantage of a steel member, is :

its high strength
its gas and water tightness
its long service life
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Steel Structure Design

If the depth of the section of an upper column is smaller than the lower column
For eccentrically loaded columns, the bending factor is
In a grillage column footing maximum bending moment M occurs at the centre of grillage beams. Its value is (where P, L and a are axial load, length of the beam and length of the column base respectively).
In a fillet weld placed on the sides of the base, the metal experiences
In a member subjected to an axial tensile force and bending moment, the maximum allowable stress in axial tension is ft and the maximum allowable bending stress in tension is fht. If ft and fht are their corresponding actual axial tensile and bending stresses, the relationship which holds goods is
In case of cantilever fillers, the ratio of the span L to depth d, should not exceed
The effective length L of a simply supported beam with ends restrained against torsion, and also the ends of compression flange partially restrained against lateral bending, is given by
Pick up the correct statement from the following:
Rolled steel beams are designated by Indian Standard series and its
The effective length of a weld, is taken as the actual length

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion