Discussion
Home ‣ Civil Engineering ‣ Strength of Materials Comments
- Question
The distance between the centres of adjacent rivets in the same row, is called
Options- A. pitch
- B. lap
- C. gauge
- D. staggered pitch.
- Correct Answer
- pitch
- 1. To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally followed, is
Options- A. middle half rule of columns
- B. middle third rule of columns
- C. middle fourth rule of columns
- D. none of these. Discuss
- 2. The neutral axis of a beam cross-section must
Options- A. pass through the centroid of the section
- B. be equidistant from the top of bottom films
- C. be an axis of symmetry of the section
- D. none of these. Discuss
- 3. The maximum compressive stress at the top of a beam is 1600 kg/cm2 and the corresponding tensile stress at its bottom is 400 kg/cm2 . If the depth of the beam is 10 cm, the neutral axis from the top, is
Options- A. 2 cm
- B. 4 cm
- C. 6 cm
- D. 8 cm
- E. 10 cm. Discuss
- 4. Simple bending equation is
Options- A.
- B.
- C.
- D.
- E. none of these. Discuss
- 5. When a rectangular beam is loaded transversely, the maximum compressive stress develops on
Options- A. bottom fibre
- B. top fibre
- C. neutral axis
- D. every cross-section. Discuss
- 6. If a steel rod of 20 mm diameter and 5 metres long elongates by 2.275 mm when subjected to an axial pull of 3000 kg, the stress developed, is
Options- A. 9.5541 kg/cm2
- B. 95.541 kg/cm2
- C. 955.41 kg/cm2
- D. 9554.1 kg/cm2. Discuss
- 7. As the elastic limit reaches, tensile strain
Options- A. increases more rapidly
- B. decreases more rapidly
- C. increases in proportion to the stress
- D. decreases in proportion to the stress. Discuss
- 8. Every material obeys the Hooke's law within its
Options- A. elastic limit
- B. plastic point
- C. limit of proportionality
- D. none of these. Discuss
- 9. The bending moment is maximum on a section where shearing force
Options- A. is maximum
- B. is minimum
- C. is equal
- D. changes sign. Discuss
- 10. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by
Options- A. 2 times
- B. 4 times
- C. 8 times
- D. 1/2 times
- E. 3 times. Discuss
Strength of Materials problems
Search Results
Correct Answer: middle fourth rule of columns
Correct Answer: pass through the centroid of the section
Correct Answer: 8 cm
Correct Answer:
Correct Answer: top fibre
Correct Answer: 955.41 kg/cm2
Correct Answer: increases more rapidly
Correct Answer: limit of proportionality
Correct Answer: changes sign.
Correct Answer: 8 times
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.