logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • Failure of riverted joints is due to


  • Options
  • A. Tearing of the plates between the rivet hole and the edge of the plate
  • B. Tearing of plates between rivets
  • C. Shearing of rivets
  • D. Crushing of rivets
  • E. All the above.

  • Correct Answer
  • All the above. 


  • Strength of Materials problems


    Search Results


    • 1. The ratio of the effective length of a column and minimum radius of gyration of its cross-sectional area, is known

    • Options
    • A. buckling factor
    • B. slenderness ratio
    • C. crippling factor
    • D. none of these.
    • Discuss
    • 2. The maximum deflection of a simply supported beam of length L with a central load W, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 3. The property of a material by which it can be drawn to a smaller section, due to tension, is called

    • Options
    • A. plasticity
    • B. ductility
    • C. elasticity
    • D. malleability.
    • Discuss
    • 4. Reactions at the supports of a structure can be determined by equating the algebraic sum of

    • Options
    • A. horizontal forces to zero
    • B. vertical forces to zero
    • C. moment about any point to zero
    • D. all the above.
    • Discuss
    • 5. The ratio of the flexural strengths of two square beams one placed with its two sides horizontal and the other placed with one diagonal vertical, diagonal, is

    • Options
    • A. 2
    • B. 2
    • C. 5
    • D. 7
    • Discuss
    • 6. When a rectangular beam is loaded transversely, the maximum compressive stress develops on

    • Options
    • A. bottom fibre
    • B. top fibre
    • C. neutral axis
    • D. every cross-section.
    • Discuss
    • 7. Simple bending equation is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E. none of these.
    • Discuss
    • 8. The maximum compressive stress at the top of a beam is 1600 kg/cm2 and the corresponding tensile stress at its bottom is 400 kg/cm2 . If the depth of the beam is 10 cm, the neutral axis from the top, is

    • Options
    • A. 2 cm
    • B. 4 cm
    • C. 6 cm
    • D. 8 cm
    • E. 10 cm.
    • Discuss
    • 9. The neutral axis of a beam cross-section must

    • Options
    • A. pass through the centroid of the section
    • B. be equidistant from the top of bottom films
    • C. be an axis of symmetry of the section
    • D. none of these.
    • Discuss
    • 10. To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally followed, is

    • Options
    • A. middle half rule of columns
    • B. middle third rule of columns
    • C. middle fourth rule of columns
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment