logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • An open-ended cylinder of radius r and thickness t is subjected to internal pressure p. The Young's modulus for the material is E and Poisson's ratio is ?. The longitudinal strain is


  • Options
  • A. zero
  • B. An open-ended cylinder of radius r and thickness t is subjected to internal pressure p. The Young's
  • C. An open-ended cylinder of radius r and thickness t is subjected to internal pressure p. The Young's
  • D. none of these.

  • Correct Answer
  • zero 


  • Strength of Materials problems


    Search Results


    • 1. In a shaft shear stress intensity at a point is not

    • Options
    • A. directly proportional to the distance from the axis
    • B. inversely proportional to the distance from the axis
    • C. inversely proportional to the polar moment of inertia
    • D. directly proportional to the applied torque.
    • Discuss
    • 2. The tension coefficient of any member is

    • Options
    • A. force divided by the length
    • B. tension divided by the length
    • C. tension per unit area
    • D. tension in the member.
    • Discuss
    • 3. The maximum stress intensity due to a suddenly applied load is x-times the stress intensity produced by the load of the same magnitude applied gradually. The value of x is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D.
    • E.
    • Discuss
    • 4. The shiftness factor for a prismatic beam of length L and moment of inertia I, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 5. A joint of a frame is subjected to three tensile force P, Q and R equally inclined to each other. If P is 10 tonnes, the other forces will be

    • Options
    • A. Q = 10 tonnes and R = zero
    • B. R + 10 tonnes and Q = zero
    • C. Q + R = 10 tonnes
    • D. Q - R = zero
    • E. Q and R each is equal to 10 tonnes.
    • Discuss
    • 6. Beams of uniform strength are preferred to those of uniform section because these are economical for

    • Options
    • A. large spans
    • B. heavy weights
    • C. light weights
    • D. short spans.
    • Discuss
    • 7. Shear force for a cantilever carrying a uniformly distributed load over its length, is

    • Options
    • A. triangle
    • B. rectangle
    • C. parabola
    • D. cubic parabola.
    • Discuss
    • 8. In a solid arch, shear force acts

    • Options
    • A. vertically upwards
    • B. along the axis of the arch
    • C. perpendicular to the axis of arch
    • D. tangentially to the arch
    • E. none of these.
    • Discuss
    • 9. A beam of length L supported on two intermediate rollers carries a uniformly distributed load on its entire length. If sagging B.M. and hogging B.M. of the beam are equal, the length of each overhang, is

    • Options
    • A. 0.107 L
    • B. 0.207 L
    • C. 0.307 L
    • D. 0.407 L
    • E. 0.5 L.
    • Discuss
    • 10. A long vertical member, subjected to an axial compressive load, is called

    • Options
    • A. a column
    • B. a strut
    • C. a tie
    • D. a stanchion
    • E. all the above.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment