Maximum deflection of a cantilever due to pure bending moment M at its free end, is

More Questions from Strength of Materials

• Euler's formula states that the buckling load P for a column of length l, both ends hinged and whose least moment of inertia and modulus of elasticity of the material of the column are I and E respectively, is given by the relation
• In the given below figure, the rivets with maximum stress, are :
• If a solid shaft is subjected to a torque T at its end such that maximum shear stress does not exceed fz the diameter of the shaft will be
• In a square beam loaded longitudinally, shear develops
• A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called
• A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be
• Pick up the correct statement from the following :
• In a simply supported beam (l + 2a) with equal overhangs (a) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if
• The principal stresses at a point are 100, 100 and-200 kgf/cm2, the octo hedral shear stress at the point is :
• If a member is subjected to a tensile force P, having its normal cross-section A, the resulting shear stress in an oblique plane inclined at an angle θ to its transverse plane, is

Discussion & Comments