Curioustab

Home » Civil Engineering » Strength of Materials

If a solid shaft is subjected to a torque T at its end such that maximum shear stress does not exceed fz the diameter of the shaft will be

none of these.

Correct Answer:

← Previous Question Next Question→

More Questions from Strength of Materials

In a square beam loaded longitudinally, shear develops
A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called
A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be
Pick up the correct statement from the following :
In a simply supported beam (l + 2a) with equal overhangs (a) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if
The principal stresses at a point are 100, 100 and-200 kgf/cm2, the octo hedral shear stress at the point is :
If a member is subjected to a tensile force P, having its normal cross-section A, the resulting shear stress in an oblique plane inclined at an angle θ to its transverse plane, is
In a simply supported beam L with a triangular load W varying from zero at one end to the maximum value at the other end, the maximum bending moment is
Strain energy of a member may be equated to
If the width b and depth d of a beam simply supported with a central load are interchanged, the deflection at the centre of the beam will be changed in the ratio of

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion