logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Irrigation Comments

  • Question
  • If A is the area of the surface, x is the depth of its C.G. from the surface of the water and ? is the density of water, then


  • Options
  • A. total pressure on the surface is equal to ? x
  • B. depth of the point at which total pressure acts is equal to its moment of inertia divided by A x
  • C. depth of the centre of pressure is 2/3H vertically below the surface
  • D. all the above.

  • Correct Answer
  • all the above. 


  • Irrigation problems


    Search Results


    • 1. The ratio of the discharge over a trapezoidal crest to a rectangular crest of Sarda falls of identical parameters, is

    • Options
    • A. 1.084
    • B. 1.074
    • C. 1.064
    • D. 1.054
    • E. 2.053
    • Discuss
    • 2. Pick up the correct statement from the following:

    • Options
    • A. Gravity water is harmful to crops
    • B. Hygroscopic water remains attached to soil molecules by chemical bond
    • C. Capillary moisture held in the soil pores against gravity by surface tension, is utilised by plants
    • D. All the above.
    • Discuss
    • 3. For a unique design of a channel by Kennedy's theory

    • Options
    • A. its breadth must only be known
    • B. its depth must only be known
    • C. its breadth and depth ratio must only be known
    • D. all the above.
    • Discuss
    • 4. The Lacey's regime velocity is proportional to

    • Options
    • A. R1/2 S3/4
    • B. Q3/4 S1/3
    • C. R3/4 S1/3
    • D. R2/3 S1/2
    • Discuss
    • 5. The length and width of a meander and also the width of the river, vary roughly as

    • Options
    • A. square root of the discharge
    • B. discharge
    • C. square of the discharge
    • D. cube of the discharge.
    • Discuss
    • 6. A land is said to be water-logged if its soil pores within

    • Options
    • A. a depth of 40 cm are saturated
    • B. a depth of 50 cm are saturated
    • C. root zone of the crops are saturated
    • D. all the above.
    • Discuss
    • 7. In rigid module, the discharge

    • Options
    • A. is independent of water levels in the distributary and water course
    • B. depends upon the water level in distributary
    • C. depends upon the water level in the water course
    • D. depends upon the water levels of both, i.e. distributary and water course
    • E. none of these.
    • Discuss
    • 8. The uplift pressure on the roof of an inverted syphon, is maximum when

    • Options
    • A. drain in running dry
    • B. canal is running dry
    • C. canal is running with F.S.L.
    • D. drain is running with H.F.L.
    • Discuss
    • 9. While deciding the alignment of a proposed canal taking off from a river at B, three alignments of approximately equal lengths are available. These cross a drainages at C1, C2 and C3 where drainage bed levels C1 > C2 > C3, you will provide at site C3

    • Options
    • A. an aqueduct
    • B. a syphon aqueduct
    • C. a super passage
    • D. a syphon.
    • Discuss
    • 10. A fall which maintains its depth, is

    • Options
    • A. a trapezoidal notch fall
    • B. a low weir fall
    • C. a rectangular notch fall
    • D. all the above.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment