logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and ?t, ? and ?c = Permissible tensile, shearing and crushing stresses respectively)


  • Options
  • A. (p - 2d)t x ?c
  • B. (p - d)t x ?
  • C. (p - d)t x ?t
  • D. (2p - d)t x ?t

  • Correct Answer
  • (p - d)t x ?t 


  • Strength of Materials problems


    Search Results


    • 1. In the below figure, __________ represents glass.

    • Options
    • A. curve A
    • B. curve B
    • C. curve C
    • D. curve D
    • Discuss
    • 2. A closely coiled helical spring is of mean diameter (D) and spring wire diameter (d). The spring index is the ratio of

    • Options
    • A. 1/d
    • B. 1/D
    • C. D/d
    • D. d/D
    • Discuss
    • 3. When a body is subjected to three mutually perpendicular stresses, of equal intensity, the ratio of direct stress to the corresponding volumetric strain is known as

    • Options
    • A. Young's modulus
    • B. modulus of rigidity
    • C. bulk modulus
    • D. Poisson's ratio
    • Discuss
    • 4. The unit of strain is

    • Options
    • A. N-mm
    • B. N/mm
    • C. mm
    • D. no unit
    • Discuss
    • 5. If the magnitude of direct stress and bending stress is equal, then there will be zero stress at one of the extreme ends of a column.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 6. When a thin cvlindrical shell is subjected to an internal pressure, the volumetric strain is (where ?1 = Hoop strain, and ?2 = Longitudinal strain)

    • Options
    • A. 2?1 - ?2
    • B. 2?1 + ?2
    • C. 2?2 - ?1
    • D. 2?2 + ?1
    • Discuss
    • 7. A beam which is fixed at one end and free at the other is called

    • Options
    • A. simply supported beam
    • B. fixed beam
    • C. overhanging beam
    • D. cantilever beam
    • Discuss
    • 8. The maximum deflection of a fixed beam of length l carrying a total load W uniformly distributed over the whole length is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 9. The maximum deflection of a cantilever beam of length l with a point load W at the free end is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 10. In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that

    • Options
    • A. stress is uniform throughout the beam
    • B. strain is uniform throughout the beam
    • C. stress is proportional to the distance from the neutral axis
    • D. strain is proportional to the distance from the neutral axis
    • Discuss


    Comments

    There are no comments.

Enter a new Comment