In a riveted joint, when the rivets in.the adjacent rows are staggered in such a

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Mechanical Engineering ‣ Strength of Materials Comments

Question
In a riveted joint, when the rivets in.the adjacent rows are staggered in such a way that every rivet is in the middle of the two rivets of the opposite row, the joint is said to be diamond riveted.
Options
A. Yes
B. No

Correct Answer

No

Strength of Materials problems

Search Results

3. Young's modulus may be defined as the ratio of
Options
A. linear stress to lateral strain
B. lateral strain to linear strain
C. linear stress to linear strain
D. shear stress to shear strain

4. A simply supported beam of length l carries a point load W at a point C as shown in the below figure. The maximum deflection lies at
Options
A. point A
B. point B
C. point C
D. between points B and C

6. When a shaft, is subjected to torsion, the shear stress induced in the shaft varies from
Options
A. minimum at the centre to maximum at the circumference
B. maximum at the centre to minimum at the circumference
C. zero at the centre to maximum at the circumference
D. maximum at the centre to zero at the circumference

7. A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
Options
A. T/2
B. T
C. 2T
D. 4T

10. When a bar of length l, width b and thickness t is subjected to a push of P, its
Options
A. length, width and thickness increases
B. length, width and thickness decreases
C. length increases, width and thickness decreases
D. length decreases, width and tickness increases

Comments

More in Mechanical Engineering: