logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • A simply supported beam of length l carries a point load W at a point C as shown in the below figure. The maximum deflection lies at
    A simply supported beam of length l carries a point load W at a point C as shown in the below figure


  • Options
  • A. point A
  • B. point B
  • C. point C
  • D. between points B and C

  • Correct Answer
  • between points B and C 


  • Strength of Materials problems


    Search Results


    • 1. A uniformly distributed load may be assumed to behave like a point load at the centre of gravity of the load for all sorts of calculations.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 2. The section modulus of a rectangular section about an axis through its C.G., is

    • Options
    • A. b/2
    • B. d/2
    • C. bd2/2
    • D. bd2/6
    • Discuss
    • 3. The maximum shear stress, in the given figure, is equal to __________ of the Mohr's circle.

    • Options
    • A. radius
    • B. diameter
    • C. circumference
    • D. area
    • Discuss
    • 4. The maximum shear stress in a thin cylindrical shell subjected to internal pressure p is

    • Options
    • A. pd/t
    • B. pd/2t
    • C. pd/4t
    • D. pd/8t
    • Discuss
    • 5. The strain energy stored in a body, when the load is gradually applied, is (where ? = Stress in the material of the body, V = Volume of the body, and E = Modulus of elasticity of the material)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 6. Young's modulus may be defined as the ratio of

    • Options
    • A. linear stress to lateral strain
    • B. lateral strain to linear strain
    • C. linear stress to linear strain
    • D. shear stress to shear strain
    • Discuss
    • 7. The proof resilience is the maximum strain energy which can be stored in a body.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 8. The Poisson's ratio for steel varies from

    • Options
    • A. 0.23 to 0.27
    • B. 0.27 to 0.30
    • C. 0.31 to 0.34
    • D. 0.32 to 0.42
    • Discuss
    • 9. In a riveted joint, when the rivets in.the adjacent rows are staggered in such a way that every rivet is in the middle of the two rivets of the opposite row, the joint is said to be diamond riveted.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 10. When a shaft, is subjected to torsion, the shear stress induced in the shaft varies from

    • Options
    • A. minimum at the centre to maximum at the circumference
    • B. maximum at the centre to minimum at the circumference
    • C. zero at the centre to maximum at the circumference
    • D. maximum at the centre to zero at the circumference
    • Discuss


    Comments

    There are no comments.

Enter a new Comment