Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.25, if the cutting speed is halved, then tool life will become
half
two times
eight times
sixteen times
Correct Answer:
sixteen times
← Previous Question
Next Question→
More Questions from
Production Engineering
Gears can be best produced on mass production by
Gears can be cut on a shaper.
Jigs are used
The hole to be drilled for tapping is __________ the outside diameter of the thread on the tap.
Dielectric is used in
The size of a lathe is specified by the
A drill mainly used in drilling brass, copper or softer materials, is
Flank wear occurs mainly on the
The hole drilled for tapping should be smaller than the tap size by twice the depth of thread.
Which of the following statement is wrong?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments