Discussion
Home ‣ Biochemical Engineering ‣ Agitation and Aeration Comments
- Question
Which of the following impellers are used for wide range of viscosities?
Options- A. paddles
- B. turbines
- C. propellers
- D. none of these
- Correct Answer
- turbines
- 1. The volume of liquid (VL) in a cylindrical reactor can be calculated from the liquid height (HL) and tank diameter (Dt) using the following equation
Options- A. VL = 4/3 x ? x HL x Dt3/8
- B. VL= HL x ? x Dt2/4
- C. VL= HL x ? x Dt2
- D. VL = 4 x ? x Dt2 Discuss
- 2. What is the ratio of diameter of impeller to the diameter of tank (Da:Dt)?
Options- A. 1 : 3
- B. 2 : 1
- C. 4 : 1
- D. 1 : 5 Discuss
- 3. Radial flow impellers
Options- A. provide high shear conditions for breaking up bubbles
- B. direct flow towards the walls of the reactor
- C. Both (a) and (b)
- D. provide low shear conditions and are suited for use in shear sensitive procesess Discuss
- 4. The oxygen uptake requirements of a microbial population is characterized by the following parameters: ?m = 0.2 h-1, K0 = 0.2 mg O2.l-1, Y0 = 0.5 mg dry weight/mg O2 and C0,crit=0.8 mg.l-1 The required concentration of cells is 1000 mg.l-1 and the saturation oxygen concentration of the medium is 5.8 mg.l-1. The required KLa must be greater than
Options- A. 64 h-1
- B. 32 h-1
- C. 16 h-1
- D. 8h-1 Discuss
- 5. If liquid density and viscosity remains constant, then the Reynolds number in a stirred tank reactor will vary with the
Options- A. impeller diameter
- B. square root of the impeller diameter
- C. square of the impeller diameter
- D. cube of the impeller diameter Discuss
- 6. The relationship between the del factor, temperature and time is given as
Options- A. ? = A.t. e-E/RT
- B. ? = 1/(A.t. e-E/RT)
- C. ? = A.t. eE/RT
- D. ? = A.t.T Discuss
- 7. The specific death rate of an organism can be expressed as
Options- A. ln 2/D
- B. D/ln2
- C. D.ln2
- D. 2.0.3/ln2 Discuss
- 8. The radius of the filter with a depth of 14 cm required for a volumetric airflow rate of 10 m3/min is approximately
Options- A. 1.6 m
- B. 0.6 m
- C. 3
- D. 6 m Discuss
- 9. The collection efficiency by interception increases with the
Options- A. increasing particle diameter
- B. increasing air flow velocity
- C. both (a) and (b)
- D. increasing particle size Discuss
- 10. The heated medium passes through a holding section, which is usually maintained in
Options- A. adiabatic conditions
- B. isothermal conditions
- C. isotropic conditions
- D. isobaric conditions Discuss
Agitation and Aeration problems
Search Results
Correct Answer: VL= HL x ? x Dt2/4
Correct Answer: 1 : 3
Correct Answer: Both (a) and (b)
Correct Answer: 64 h-1
Correct Answer: square of the impeller diameter
Correct Answer: ? = A.t. e-E/RT
Correct Answer: ln 2/D
Correct Answer: 0.6 m
Correct Answer: increasing particle size
Correct Answer: adiabatic conditions
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.