Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Biochemical Engineering
»
Agitation and Aeration
In the bubble boundary layer, oxygen concentration can be determined by measuring
the steady state oxygen concentration in a mixed aerated reactor before inoculation
the steady state oxygen concentration in a mixed aerated reactor after inoculation
the steady state oxygen concentration in the boundary layer using a micro-probe
volume of oxygen supplied
Correct Answer:
the steady state oxygen concentration in a mixed aerated reactor before inoculation
← Previous Question
Next Question→
More Questions from
Agitation and Aeration
The addition of antifoams to an aerated bioreactor will decrease oxygen transfer rates because antifoams
The dynamic technique is based on the
During aeration, a cylindrical reactor had a height of 10 m. Without aeration, the height was 7.5 m. Under these aeration and mixing conditions, the gas hold up in the reactor is
A cylindrical reactor has a liquid volume of 100,000 litres. It has an aspect ratio the ratio of the channel height to width of 1:1. The height of the liquid in the reactor will be approximately:
When the height of an aerated bioreactor is increased, it will increase the oxygen transfer rate by
Power number (Np) is also known as
Which of the following would be best described as a radial flow impeller?
Main reason for using baffles in stirred tank reactors are
Small propellers turn at the speed of either
A microbial population in a suspension culture will only be limited by oxygen availability if the dissolved oxygen
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments