logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Agitation and Aeration Comments

  • Question
  • Which have the maximum resistance while transferring carbon dioxide from the bulk liquid to an air bubble?


  • Options
  • A. Moving through the gas liquid interface
  • B. Moving through the bubble boundary layer
  • C. Moving across the cell membrane
  • D. Moving through the bulk liquid

  • Correct Answer
  • Moving through the bubble boundary layer 


  • Agitation and Aeration problems


    Search Results


    • 1. The lowest yield of ATP /is in

    • Options
    • A. fermentation
    • B. aerobic respiration
    • C. anaerobic respiration
    • D. same in (a), (b) and (c)
    • Discuss
    • 2. The growth of an organism on glucose is described by the following Monod model parameters: ?m = 0.5 h-1 and Ks =0.1 g.l-1, if the concentration of glucose in the feed is 10 g.l-1 and the dilution rate is set to 0.4 h-1, then the steady state concentration of glucose in the effluent will be

    • Options
    • A. 0 g.l-1
    • B. 0.5 g.l-1
    • C. 1.0 g.l-1
    • D. 10 g.l-1
    • Discuss
    • 3. Immobilized cell reactors for wastewater treatment have the advantage of having/being

    • Options
    • A. higher cell concentration
    • B. more stable and prevent washout
    • C. higher dilution rate before the cells washout
    • D. all of the above
    • Discuss
    • 4. In aerobic yeast fermentation for production of citric acid from alkanes using a fed-batch culture, why alkanes are slowly fed to the yeast?

    • Options
    • A. Citric acid is toxic to the cells
    • B. Alkanes cause foaming
    • C. Fast addition of alkanes will inhibit the cells and reduce oxygen transfer rates
    • D. Fast addition of alkanes will cause the cells to grow too quickly
    • Discuss
    • 5. Low dissolved oxygen concentrations leads to

    • Options
    • A. low biomass yields
    • B. high biomass yields
    • C. no effect on biomass yields
    • D. none of the above
    • Discuss
    • 6. Penetration theory assumes that turbulent eddies travel from the bulk of the phase to the interface where they remain constant for a constant exposure time (te). The model correlating KL, mass transfer coefficient and DAB, diffusivity can be expressed as

    • Options
    • A. KL = 2(DAB/?te)0.25
    • B. KL = 2(DAB/?te)0.5
    • C. KL = 2(DAB/?te)0.75
    • D. KL = 2(DAB/?te)
    • Discuss
    • 7. Surface renewal theory predicts that the mass transfer coefficient is

    • Options
    • A. directly proportional to the square root of the molecular diffusivity
    • B. inversely proportional to the square root of the molecular diffusivity
    • C. directly proportional to the cube root of the molecular diffusivity
    • D. indirectly proportional to the cube root of the molecular diffusivity
    • Discuss
    • 8. Which of the following would be best described as an axial flow impeller?

    • Options
    • A. An impeller with blades pitched at 45° to the vertical
    • B. An impeller which directs liquid flow towards the base of the reactor
    • C. Both (a) and (b)
    • D. An impeller with blades pitched at 75° to the vertical
    • Discuss
    • 9. Which of the following type(s) of stirrer can be used for microbiological processes?

    • Options
    • A. Mig
    • B. Intermig
    • C. Turbine
    • D. All of these
    • Discuss
    • 10. Which of the following is most likely to cause an increase in the rate of oxygen transfer into a particular aerated fermentation system?

    • Options
    • A. Addition of antifoams
    • B. Increase in temperature
    • C. Increase in stirrer speed
    • D. Both (a) and (b)
    • Discuss


    Comments

    There are no comments.

Enter a new Comment