Discussion
Home ‣ Biochemical Engineering ‣ Fermentation Kinetics Comments
- Question
A higher Ks value of Monod's equation means
Options- A. greater affinities to substrate
- B. lower affinities to substrate
- C. unaffected with the substrate bonding
- D. lower dissociation constant value
- Correct Answer
- greater affinities to substrate
- 1. The maximum specific growth rate of an organism depends on
Options- A. medium composition
- B. temperature
- C. pH
- D. All of these Discuss
- 2. The increased air flow rate in bubble column fermenter can cause excessive foaming and high retention of air bubbles in the column which
Options- A. decreases the productivity of the fermenter
- B. increases the productivity of the fermenter
- C. modestly increases the productivity of the fermenter
- D. does not affect on the productivity Discuss
- 3. The enzyme used to reduce bitterness of grapes commonly contains
Options- A. ?-L-rhamonosidase
- B. ?-d-glucosidase
- C. ?- galactosidase
- D. both (a) and (b) Discuss
- 4. Liquefaction of starch to dextrin is carried out by
Options- A. ?-amylase
- B. cellulase
- C. pectinase
- D. all of these Discuss
- 5. Chymosin hydrolyses the bond between
Options- A. Alanine and glycine
- B. Phenyl alanine and methonine
- C. Glutamic acid and alanine
- D. Alanine and phenyl alanine Discuss
- 6. The high oxygen transfer efficiencies of airlift bioreactors is due to
Options- A. the large aspect ratio of the reactor, which leads to a high gas hold-up
- B. the large aspect ratio of the reactor, which leads to a high oxygen solubility at the base of the reactor
- C. the draft tube, which reduces bubble coalescence in the reactor
- D. all of the above Discuss
- 7. Stationary phase is described as
Options- A. no further increase in the cell population after a maximum value
- B. deceleration of growth and division rate after the growth rate reaches a maximum
- C. acceleration of growth and division rate after the growth rate reaches a maximum
- D. deceleration of growth and division rate after the growth rate reaches a minimum Discuss
- 8. Which of the following is correct for the prediction of time requirement in a batch fermenter?
Options- A. Carrying out experiments
- B. Mathematical modelling of the fermentation process
- C. Both (a) and (b)
- D. It is impossible to predict the time required for fermentation Discuss
- 9. Heat transfer rates (per unit volume) will be lowest in
Options- A. Stirred tank bioreactor with biomass recycle
- B. Continuous air lift bioreactor
- C. Continuous packed bed reactor
- D. Continuous fluidized bed bioreactor Discuss
- 10. The number of baffles in a standard stirred tank bioreactor is
Options- A. 8
- B. 6
- C. 4
- D. 2 Discuss
Fermentation Kinetics problems
Search Results
Correct Answer: All of these
Correct Answer: decreases the productivity of the fermenter
Correct Answer: both (a) and (b)
Correct Answer: ?-amylase
Correct Answer: Phenyl alanine and methonine
Correct Answer: all of the above
Correct Answer: no further increase in the cell population after a maximum value
Correct Answer: Both (a) and (b)
Correct Answer: Continuous packed bed reactor
Correct Answer: 4
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.