Discussion
Home ‣ Civil Engineering ‣ Steel Structure Design Comments
- Question
If the depth of two column sections are equal, then the column splice is provided
Options- A. with filler plates
- B. with bearing plates
- C. with filler and hearing plates
- D. none of these.
- Correct Answer
- none of these.
- 1. The distance between e.g. of compression and e.g. of tension flanges of a plate girder, is known as
Options- A. overall depth
- B. clear depth
- C. effective depth
- D. none of these. Discuss
- 2. Pick up the correct statement from the following:
Options- A. When the gauge distance is larger than the pitch, the failure of the section may occur in a zig-zag line
- B. When the gauge distance is smaller than the pitch, the failure of the section may occur in a straight right angle section through the centre of rivet holes
- C. When the gauge distance and pitch are both equal, the failure to the section becomes more likely as the diameter of the holes increases
- D. All the above. Discuss
- 3. Live load
Options- A. varies in magnitude
- B. varies in position
- C. is expressed as uniformly distributed load
- D. All the above. Discuss
- 4. The most economical section for a column, is
Options- A. rectangular
- B. solid round
- C. flat strip
- D. tubular section
- E. hexagonal. Discuss
- 5. If d is the distance between the flange angles, the vertical stiffeners in plate girders are spaced not greater than
Options- A. d
- B. 1.25 d
- C. 1.5 d
- D. 1.75 d Discuss
- 6. For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (excepting the webs of Indian Standard rolled steel joists and channels).
Options- A. 4 mm
- B. 6 mm
- C. 8 mm
- D. 10 mm Discuss
- 7. Secant formula for direct stress in compression, is applicable only for slenderness ratio upto
Options- A. 120
- B. 130
- C. 140
- D. 150
- E. 160 Discuss
- 8. The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
Options- A.
- B.
- C.
- D.
Discuss
- 9. When a tension member is made of four angles with a plate as a web, the allowance for holes is made as
Options- A. two holes for each angle and one hole for the web
- B. one hole for each angle and one hole for the web
- C. one hole for each angle and two holes for the web
- D. two holes for each angle and two holes for the web
- E. none of these. Discuss
- 10. The minimum edge distance of a rivet line connecting two or more plates, is kept equal to 37 mm plus (where t is the thickness in mm of the thinner outside plate).
Options- A. 2 t
- B. 4 t
- C. 6 t
- D. 8 t
- E. 10 t Discuss
Steel Structure Design problems
Search Results
Correct Answer: effective depth
Correct Answer: All the above.
Correct Answer: All the above.
Correct Answer: tubular section
Correct Answer: 1.5 d
Correct Answer: 6 mm
Correct Answer: 140
Correct Answer:
Correct Answer: one hole for each angle and two holes for the web
Correct Answer: 4 t
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.