logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Steel Structure Design Comments
  • Question

  • In plastic analysis, the shape factor for circular sections, is


  • Options
  • A. 1.5
  • B. 1.6
  • C. 1.697
  • D. none of these.

  • Correct Answer
  • 1.697 

    • Steel Structure Design problems

    Search Results

    • 1. If flexural rigidity of a column whose length is L and the loaded end is free, is El, the critical load will be

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 2. According to IS : 800 - 71, the minimum thickness of a vertically stiffened web plate, shall not be less than

    • Options
    • A.
    • B.
    • C.
    • D.
    • E. none of these.
      • Discuss
    • 3. Slenderness ratio of a compression member is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 4. Web crippling generally occurs at the point where

    • Options
    • A. bending moment is maximum
    • B. shearing force is minimum
    • C. concentrated loads act
    • D. deflection is maximum
    • E. all the above.
      • Discuss
    • 5. For a rectangular section, the ratio of the maximum and average shear stresses, is

    • Options
    • A. 1.5
    • B. 2.0
    • C. 2.5
    • D. 3.0
    • E. 4.0
      • Discuss
    • 6. The allowable stress in axial tension for rolled I-sections and channels, is taken as

    • Options
    • A. 1420 kg/cm2
    • B. 1500 kg/cm2
    • C. 2125 kg/cm2
    • D. 1810 kg/cm2
      • Discuss
    • 7. If the moment of inertia of a section about its axis is I and its effective sectional area is A, its radius of gyration r about the axis, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 8. The area Ap of cover plates in one flange of a built up beam, is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • E. none of these.
      • Discuss
    • 9. To keep the intensity of bearing pressure between the column base and concrete compressive and to vary from zero to , the ratio of the moment M to the axial load P should be

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 10. The method of design of steel framework for greatest rigidity and economy in weight, is known as

    • Options
    • A. simply design
    • B. semi-rigid design
    • C. fully rigid design
    • D. none of these.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.