CuriousTab
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank Clerk
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Civil Engineering
‣
Building Construction
See What Others Are Saying!
Question
Dado is usually provided in
Options
A. dinning halls
B. bath rooms
C. living rooms
D. verandah
E. roofs.
Correct Answer
bath rooms
More questions
1. The greatest eccentricity which a load
W
can have without producing tension on the cross-section of a short column of external diameter
D
and internal diameter
d
, is
Options
A.
B.
C.
D.
E.
Show Answer
Scratch Pad
Discuss
Correct Answer:
2. Pick up the correct statement from the following :
Options
A. The distance between two successive crests or troughs of a wave, is called, the wave length
B. The wave length is measured in metres and a fraction of a metre
C. The wave length is generally denoted by ?
D. The length of the crest from the mid point, is called amplitude
E. All of these
Show Answer
Scratch Pad
Discuss
Correct Answer: All of these
3. Pick up the correct statement from the following:
Options
A. Uniform series compound amount factor =
B. Uniform series present worth factor =
C. Sinking fund factor =
D. Capital recovery factor =
where letters carry their usual meanings.
E. All of these
Show Answer
Scratch Pad
Discuss
Correct Answer: All of these
4. The correction applied to the measured base of length
L
is
Options
A.
B.
where
w
is the weight of tape/m
C.
where
h
is height difference of end supports
D. Reduction to mean sea level =
E. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
5. For an ordinary Portland cement
Options
A. residual does not exceed 10% when sieved through IS Sieve No. 9
B. soundness varies from 5 to 10 mm
C. initial setting time is not less than 30 minutes
D. compressive stress after 7 days, is not less than 175 kg/cm
2
E. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: initial setting time is not less than 30 minutes
6. Pick up the correct statement from the following:
Options
A. Permeability is a measure of conducting the magnetic lines of force in the material.
B. Permeability is a measure of the extent to which magnetic lines of force can penetrate a medium.
C. Permeability is expressed as the ratio of the magnetic flux density (
B
) to the field strength of the magnetizing field.
D. The force between the magnetic poles is inversely proportional to the permeability of the medium.
E. All of these
Show Answer
Scratch Pad
Discuss
Correct Answer: All of these
7.
M
- ? relationship for a simply supported beam shown below is given by :
Options
A.
M l
/
EI
= 2?
B.
M l
/
EI
= 3?
C.
M l
/
EI
= 4?
D.
M l
/
EI
= 6?
Show Answer
Scratch Pad
Discuss
Correct Answer:
M l
/
EI
= 4?
8. The altitude of a heavenly body is its angular distance, measured on the vertical circle passing through the body, above
Options
A. equator
B. horizon
C. pole
D. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: horizon
9. The difference in longitude of two places expressed in time is equal to the difference in their
Options
A. sidereal time
B. apparent solar time
C. mean solar time
D. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
10. Design rate of super elevation for horizontal highway curve of radius 450 m for a mixed traffic condition, having a speed of 125 km/hour is
Options
A. 1.0
B. 0.05
C. 0.07
D. 0.154
Show Answer
Scratch Pad
Discuss
Correct Answer: 0.154
Comments
There are no comments.
Enter a new Comment
Save
More in Civil Engineering:
Advanced Surveying
Airport Engineering
Applied Mechanics
Building Construction
Building Materials
Concrete Technology
Construction Management
Docks and Harbours
Elements of Remote Sensing
Engineering Economy
Estimating and Costing
GATE Exam Questions
Highway Engineering
Hydraulics
Irrigation
Railways
RCC Structures Design
SI Units
Soil Mechanics and Foundation Engineering
Steel Structure Design
Strength of Materials
Structural Design Specifications
Surveying
Theory of Structures
Tunnelling
UPSC Civil Service Exam Questions
Waste Water Engineering
Water Resources Engineering
Water Supply Engineering