If E, N, K and 1/m are modulus of elasticity, modulus of rigidity. Bulk modulus

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Civil Engineering ‣ Theory of Structures Comments

Question
If E, N, K and 1/m are modulus of elasticity, modulus of rigidity. Bulk modulus and Poisson ratio of the material, the following relationship holds good
Options
A.
B.
C.
D. all the above.

Correct Answer

all the above.

Theory of Structures problems

Search Results

1. There are two hinged semicircular arches A, B and C of radii 5 m, 7.5 m and 10 m respectively and each carries a concentrated load W at their crowns. The horizontal thrust at their supports will be in the ratio of
Options
A. 1 : 1 1/2 : 2
B. 2 : 1 1/2 : 1
C. 1 : 1 : 2
D. none of these.

5. Pick up the correct statement from the following:
Options
A. The point of intersection of the bending axis with the cross section of the beam, is called shear centre
B. For I sections, the shear centre coincides with the centroid of the cross section of the beam
C. For channels, the shear centre does not concide its centroid
D. Bending loads should pass through the shear centre to avoid twisting
E. All the above.

6. Two bars, one of steel and the other of copper having areas of cross-sections A_s and A_c, coefficient of expansion ?s and ?c and Young's Modulii E_s and E_s are rigidly connected together at the ends and subjected to temperature change of t�. If the length of the bars initially is L, the final extension ? of the two bars at t� temperature is given by
Options
A.
B.
C.
D.

8. Pick up the correct statement from the following:
Options
A. The bending moment which when acting alone would produce the maximum stress equal to the major principal stress caused by combined bending and torsion, is called equivalent bending moment
B. M_cg = (M M² + r²) where letters carry their usual meanings
C. T_cp = m² + T² where letters carry their usual meanings
D. The torque which when acting alone would produce maximum shear stress equal to the maximum shear stress caused by the combined bending and torsion, is called equivalent torque
E. All the above.

10. The tangential component of stress on an plane inclined ?� to the direction of the force, may be obtained by multiplying the normal stress by
Options
A. sin ?
B. cos ?
C. tan ?
D. sin ? cos ?
E. sin²?

Comments

More in Civil Engineering: