Curioustab

Home » Civil Engineering » Theory of Structures

A load of 1960 N is raised at the end of a steel wire. The minimum diameter of the wire so that stress in the wire does not exceed 100 N/mm2 is :

4.0 mm
4.5 mm
5.0 mm
5.5 mm
6.0 mm

Correct Answer: 5.0 mm

← Previous Question Next Question→

More Questions from Theory of Structures

If ΣH and ΣV are the algebraic sums of the forces resolved horizontally and vertically respectively, and ΣM is the algebraic sum of the moments of forces about any point, for the equilibrium of the body acted upon
Pick up the correct statement from the following:
The ratio of maximum shear stress to average shear stress of a circular beam, is
In plastic analysis, the shape factor for a circular section, is
The normal component of a force inclined through θ° is obtained by multiplying the force by
For calculating the allowable stress of long columns. The empirical formula , is known as
The stiffness of the close coil helical spring is
The maximum deflection due to a uniformly distributed load w/unit length over entire span of a cantilever of length l and of flexural rigidly EI, is
In plastic analysis, the shape factor for a triangular section, is
A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm2, the side of the rod, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion